Advanced Logic Research Solo 9100 Especificaciones descargar pdf (Pagina 85)

74 Maintaining and Troubleshooting Your E-4200 System

The IDE drive is not recognized by the system.

Memory/Processor problems

Memory errors were detected during system start up.

Probable Cause Solution

The primary IDE

device may be config-

ured incorrectly.

Restart your computer, and then press

enter the setup program. From the

Main

menu, set the

Primary IDE Master

Auto Con-

figured

The drive may not be

configured properly.

Consult the hard disk user’s guide for

instructions on how to configure the drive.

The drive cables are

not connected prop-

erly.

Open the system and check all cables con-

nected to the controller card.

The drive controller is

not seated properly.

Open the system and reseat the drive con-

troller.

Probable Cause Solution

Memory was added or

removed, and the new

configuration was not

saved in BIOS Setup.

Enter BIOS Setup and save the new mem-

ory configuration.

The memory was

installed incorrectly.

Check the memory for proper seating and

orientation.

A memory chip is

faulty.

Replace the card on which the faulty chip

resides. Third-party diagnostic programs

can help determine which chip or memory

segment is failing.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 107 108

Comentarios a estos manuales

Sin comentarios

Advanced Logic Research Solo 9100 Especificaciones Pagina 85

Comentarios a estos manuales